Hi,
I wonder if any of you guys can help with a problem that I have? I wish to acquire data of utilization on Gig E interfaces on a Cisco 7200. I use the OID's ifInOctets and ifOutOctets in my config file reading the 32bit counters. The graphs produced seem to be displaying incorrect results. I am comparing my results to that acquired by cricket. I'm sure that my syntax is correct. See syntax below for interface 149. Target[<name>]: ifInOctets.149&ifOutOctets.149:<communitystring>@<device IP> Another problem I found is that I cannot get any data usung 64bit counter OID's, ie. ifHCInOctets and ifHCOutOctets. Thanks, Faiqo Please note: This email and its content are subject to the disclaimer as displayed at the following link http://www.is.co.za/legal/E-mail+Confidentiality+Notice+and+Disclaimer.htm. Should you not have Web access, send a mail to [EMAIL PROTECTED] and a copy will be emailed to you.
_______________________________________________ mrtg-developers mailing list [email protected] https://lists.oetiker.ch/cgi-bin/listinfo/mrtg-developers
