Hi Jerry, If you run cfgmaker without any arguments, it will display it's help, in the help it has the following options to solve your problem:
--no-down do not look at admin or opr status of interfaces --show-op-down show interfaces which are operatively down i.e. cfgmaker --show-op-down [EMAIL PROTECTED] Which will produce a config file which has all ports that are not administratively set to shutdown shown. If you want all ports regardless of their state, i.e. up, down, administratively down, use the --no-down option. Kind regards, Warrick Mitchell Network Engineer ALCOA World Alumina of Australia * Phone: 9316 5160 Fax: 9316 5228 * E-mail: <mailto:[EMAIL PROTECTED]> -----Original Message----- From: Jerry Hsieh [mailto:[EMAIL PROTECTED] Sent: Wednesday, January 15, 2003 09:15 To: mrtg Subject: [mrtg] MRTG with Cisco 2900 series switch Hi all, I am trying to use MRTG to monitor traffic on Cisco 2900 switches. When I run cfgmaker, the cfg file will comment out the ports are not activate(no system connected). Is there any way to enable this? Thanks for your time. Regards, Jerry Hsieh -- Unsubscribe mailto:[EMAIL PROTECTED] Archive http://www.ee.ethz.ch/~slist/mrtg FAQ http://faq.mrtg.org Homepage http://www.mrtg.org WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi -- Unsubscribe mailto:[EMAIL PROTECTED] Archive http://www.ee.ethz.ch/~slist/mrtg FAQ http://faq.mrtg.org Homepage http://www.mrtg.org WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
