Content-Type: text/plain Ok... I have been reading up on MRTG for a while. I am having a couple of issues with it, but I'll just address one here for now. This problem may be obvious to everyone else, but for some reason I am just not getting it. Let's say I have a Cisco 6513 switch with the following parameters. IP: 192.168.1.1 RO Community String: grooving Everyone here probably knows well and good that when I run config maker it will only give me the configs for interface in/out info. What if I wanted to monitor a different OID? Can I use config maker with an output variable to do this or do I just have to know how to write the config? Say I want to monitor the following OID (Just grabbing one as an example):
CISCO-SMI 1.3.6.1.4.1.9.9.109.1.2.1.1.2.9.9 ciscoMgmt.109.1.2.1.1.2.9.9 TempMon Can someone please help? What I am actually trying to do is monitor air intake temperature. We are in a very hot environment, the Middle East, and this temp. would represent our ITN ambient temperature so that we can keep our equipment from overheating. Thanks for the help! Lee Crow Senior LAN/WAN Administrator ITT Systems _____ DSN: 471-2074 Cell: +974-556-3127 <mailto:[EMAIL PROTECTED]> [EMAIL PROTECTED] -- Attached file removed by Ecartis and put at URL below -- -- Type: image/gif -- Size: 2k (2156 bytes) -- URL : http://www.ee.ethz.ch/~slist/pantomime/27-image001.gif -- Unsubscribe mailto:[EMAIL PROTECTED] Archive http://www.ee.ethz.ch/~slist/mrtg FAQ http://faq.mrtg.org Homepage http://www.mrtg.org WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
