Assuming these are 10/100 ethernet ports there is usually a device configuration setting to lock the speed per port. I would suggest locking the speed (and duplex for that matter) and see if that results in a config file with real maximums.
}-----Original Message----- }From: Aaron.Conaway [mailto:[EMAIL PROTECTED] }Sent: Thursday, January 30, 2003 1:58 PM }To: mrtg }Subject: [mrtg] Alteons -- Speed set to 0? } } } }I have a pair of Alteons doing load balancing of our web }servers that I could like to monitor with MRTG; however, when }I run cfgmaker against them, all the interfaces are commented }out with reason "has a speed of 0 which makes no sense." }Since all the interfaces are commented out, it does me very }little good to see an empty web page. :-) } }Has anyone seen this issue? How can I get around this? Any thoughts? } }I found a few messages in the archive that pertain to this, }but, when I click them, it takes me to a different thread. }Please forgive the ignorance. } }Thanks... } }Aaron Conaway }Network Engineer III }Verisign TSD }Phone: 912.527.4343 } }-- }Unsubscribe mailto:[EMAIL PROTECTED] }Archive http://www.ee.ethz.ch/~slist/mrtg }FAQ http://faq.mrtg.org Homepage http://www.mrtg.org }WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi } } -- Attached file removed by Ecartis and put at URL below -- -- Type: application/ms-tnef -- Size: 2k (2206 bytes) -- URL : http://www.ee.ethz.ch/~slist/pantomime/39-WINMAIL.DAT -- Unsubscribe mailto:[EMAIL PROTECTED] Archive http://www.ee.ethz.ch/~slist/mrtg FAQ http://faq.mrtg.org Homepage http://www.mrtg.org WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
