I may be wrong, but I thought that the ifInNUcastPkts and ifOutNUcastPkts were deprecated.
}I was wondering if }anyone knows }of how to graph broadcast packets on a Cisco 6509? All of the }interfaces You'll want to poll the interfaces.ifTable.ifEntry.ifInNUcastPkts.<interfacenumber> and interfaces.ifTable.ifEntry.ifOutNUcastPkts.<interfacenumber> NU is for NON-UNICAST, so you'll get broadcast and multicast packets. You can download the following template: http://mrtg.gvolk.com/template/interface-genericsnmp.template <http://mrtg.gvolk.com/template/interface-genericsnmp.template> and use it with cfgmaker to generate MRTG configs for typical snmp interface based variables, one of which is NU packets in/out. }are GigE...I'm not too sure if the super speed would have any }impact on the }counters (use 64 or 32 bit counters ???). Thanks very much. } As a general rule when I build in/out octets configs for my 6500 switches, I always use 64 bit counters. It's not necessary on 10/100 ports, but is an issue on gig-e ports that sustain more than about 10% utilization. At five minute poll intervals, you'll run into accuracy problems with 32 bit counters past a sustainted rate of 114mbits/sec. Jason D. Humes Applied Computer Solutions 3020 St. Etienne Blvd. Windsor, Ont. Phone : (519) 944-4300 Fax : (519) 944-4247 Email : [EMAIL PROTECTED] -- Unsubscribe mailto:[EMAIL PROTECTED] Archive http://www.ee.ethz.ch/~slist/mrtg FAQ http://faq.mrtg.org Homepage http://www.mrtg.org WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
