Peter... I am sorry that I cannot help you with your VPN issue, however I couldn't help but note that you have a Sonicwall Pro100. There are many people on this list that have tried to use the SW MIBs to get SNMP/MRTG working, but haven't been able to. I noticed the ... after your MIB entry. Are you able to get stats out of your WAN/LAN/DMZ interfaces? Would you mind sharing your entire sonicwall config to help out the rest of us?
AD Peter Erickson wrote: > I am trying to graph the amount of information that is encrypted from our vpn > gateway, but am running into a problem. Within the sonicwall, there is an > index into a table for each SA. Since the sonicwall doest have a OID for all > info encrypted and decrypted, im taking each SA and adding them all together. > So currently, the cfg file looks like: > > Target[Sonic_vpn]: > 1.3.6.1.4.1.8741.1.3.2.1.1.1.9.38&1.3.6.1.4.1.8741.1.3.2.1.1.1.11.38:[EMAIL > PROTECTED] > + > 1.3.6.1.4.1.8741.1.3.2.1.1.1.9.39&1.3.6.1.4.1.8741.1.3.2.1.1.1.11.39:[EMAIL > PROTECTED] > + ... > SetEnv[Sonic_vpn]: MRTG_INT_IP="172.20.1.2" MRTG_INT_DESCR="eth0" > Options[Sonic_vpn]: noinfo,nopercent > MaxBytes[Sonic_vpn]: 1250000 > Title[Sonic_vpn]: VPN Traffic Analysis for SonicWALL PRO/100 > PageTop[Sonic_vpn]: <H1>VPN Traffic Analysis for SonicWALL PRO/100</H1> > <TABLE> > <TR><TD>System:</TD> <TD>PRO/100 in Edina</TD></TR> > <TR><TD>Maintainer:</TD> <TD>[EMAIL PROTECTED]</TD></TR> > <TR><TD>Description:</TD><TD>eth0 </TD></TR> > <TR><TD>ifType:</TD> <TD>ethernetCsmacd (6)</TD></TR> > <TR><TD>ifName:</TD> <TD></TD></TR> > <TR><TD>Max Speed:</TD> <TD>1250.0 kBytes/s</TD></TR> > <TR><TD>Ip:</TD> <TD>172.20.1.2</TD></TR> > </TABLE> > > As I was running MRTG, I just realized that as these SAs are created and torn > down, the index into the tables change and when an SA goes away,. MRTG stops > graphing an starts emailing me all these errors. The first value of the > target is EncryptedByteCount and the second is DecryptedByteCount. The > question that I have is this. Is there a way to setup the target so that it > goes through all possible values within the ByteCount arrays and adds the > values or do I need to write a custom script that will do this for me and set > the target to that value? And if I need to write a script, can someone point > me in the right direction for finding out how to do this? > > I really appreciate any help on this one. Im on a short timeline. Thanks. -- Unsubscribe mailto:[EMAIL PROTECTED] Archive http://www.ee.ethz.ch/~slist/mrtg FAQ http://faq.mrtg.org Homepage http://www.mrtg.org WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
