Hello, (mrtg-2.9.21)
I have a 10Mb line on eth0 which is normally only used for internet access at 512kb/s. I'm only interested in all traffic below these 512kb/s. I therefore use: Unscaled[host_5]: dwmy MaxBytes[host_5]: 64000 But sometimes I have a 10Mb/s connection through this interface. To avoid that peaks of 10Mb/s connection "hide" the 512kb/s statistics, I use the Unscaled option. But I can't find a solution to the following problem: The MaxBytes option throws away all traffic above 64000 Bytes, but I would like that the traffic above 64000 Bytes is shown as "64000 Bytes", not zero Bytes. Is that possible? Richard. -- ___________________________________________________________________ Recursion: see recursion +------------------------------------------------------------------+ | Richard Lucassen, Utrecht, Linux 2.4.20 RedHat 7.2 | | The Netherlands i686/1200MHz/768MB | | Public key: http://www.xs4all.nl/~pe1bbf/pubkey.asc | +------------------------------------------------------------------+ -- Binary/unsupported file stripped by Ecartis -- -- Err : No filename to use for decode, file stripped. -- Type: application/pgp-signature -- Unsubscribe mailto:[EMAIL PROTECTED] Archive http://www.ee.ethz.ch/~slist/mrtg FAQ http://faq.mrtg.org Homepage http://www.mrtg.org WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
