It's in the mrtg code itself. Go looking for:... @main::DEBUG=qw(); # DEBUG TARGETS # cfg - watch the config file reading # dir - directory mangeling # base - basic program flow # tarp - target parser # snpo - snmp polling # fork - forking view # time - some timing info # log - logging of data via rateup or rrdtool
...(or reasonable facsimile thereof). Insert the type of debugging you need in the brackets. (I've only found the need for DEBUG=qw(base), myself). You'll need to restart mrtg for the change to take effect. Then you'll need to restart (again!) when you want to remove DEBUG.... -----Original Message----- From: Edson Manners [mailto:[EMAIL PROTECTED] Sent: Tuesday, 15 April 2003 4:27 AM To: [EMAIL PROTECTED] Subject: [mrtg] Set MRTG to run and give debug messages I read somewhere that there was some flag that could be set to make mrtg run in debug mode. For example, if it gets no values from certain queries it logs or emails to root. I can't seem to find this on the MRTG web page or the archives. Does anyone know/remember this offhand? -- Education's purpose is to replace an empty mind with an open one. - Unknown Edson Manners Academic Computing and Network Systems Florida State University -- Unsubscribe mailto:[EMAIL PROTECTED] Archive http://www.ee.ethz.ch/~slist/mrtg FAQ http://faq.mrtg.org Homepage http://www.mrtg.org WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi ********************************************************************** This message is intended for the addressee named and may contain privileged information or confidential information or both. If you are not the intended recipient please delete it and notify the sender. ********************************************************************** -- Unsubscribe mailto:[EMAIL PROTECTED] Archive http://www.ee.ethz.ch/~slist/mrtg FAQ http://faq.mrtg.org Homepage http://www.mrtg.org WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
