You could probably uncomment them, and then check out the resulting graphs
and see if they look realistic. I have RSMs too, but I haven't tried to
monitor them. I monitor the links on the Cat5500 in my case. Seems like you
would get good data, just as you would any other router.
Hey, maybe you know the answer to this: I have asked Cisco several times,
and no one seems to know the max throughput of the RSM. After digging
around and looking for something definitive, they always come back saying
that the SH PORT on the Catalyst 5500 indicates the trunk going to the RSM
says 400MB half duplex, so that must be the answer. Would you happen to
know otherwise, or where that max throughput figure may be defined?
Jim Witherell
Network Specialist --Live Intentionally--
IBM @ AK Steel Corp
513.425.3483
"Leonard Miller"
<[EMAIL PROTECTED] To: <[EMAIL PROTECTED]>
dlp.com> cc:
Sent by: Subject: [mrtg] MRTG & VLANs
[EMAIL PROTECTED]
ee.ethz.ch
06/26/2003 09:52
AM
Hi,
I've looked for an answer to this, but nothing I found gave a real
good explanation or answer.
I have a Cisco RSM, Version 12.0(8), that I want to start monitoring
and when I run cfgmaker, all interfaces are commented out because
they are VLAN's.
Can I just uncomment the sections or do I need to do
something else?
Thanks
Leonard
--
Unsubscribe mailto:[EMAIL PROTECTED]
Archive http://www.ee.ethz.ch/~slist/mrtg
FAQ http://faq.mrtg.org Homepage http://www.mrtg.org
WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
--
Unsubscribe mailto:[EMAIL PROTECTED]
Archive http://www.ee.ethz.ch/~slist/mrtg
FAQ http://faq.mrtg.org Homepage http://www.mrtg.org
WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
