Wong, I have done this redently. I didn't do anything special (may have been using V2c SNMP queries which will fall back to V1 if they fail) and they showed up.
The device was a Cisco 7513 running IOS 12.0(24)S2 and V2.9.28 of MRTG. However, I have noticed inconsistancies with the numbers reported by the GigE sub-if and the switch port at the other end. I may be missing something, but at this point I feel more comfortable trusting what the switch is reporting than the GigE subinterface.. Tim -----Original Message----- From: Wong, Hon-Cheong [mailto:[EMAIL PROTECTED] Sent: Fri 8/29/2003 7:10 AM To: '[EMAIL PROTECTED]' Cc: Subject: [mrtg] GE sub-interface traffic measurement Hi Everyone, Did anyone has try to collect the in/out octet information over sub-interface in a GE port ? I have try to built the configuration file using cfgmaker and found only the GE port traffic is being collected rather the sub-interface traffic, but the method is really work for ATM and serial interface. Can you help me for the issue. Thanks in advance. With Best Regards, HC Wong -- Unsubscribe mailto:[EMAIL PROTECTED] Archive http://www.ee.ethz.ch/~slist/mrtg FAQ http://faq.mrtg.org Homepage http://www.mrtg.org WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi -- Unsubscribe mailto:[EMAIL PROTECTED] Archive http://www.ee.ethz.ch/~slist/mrtg FAQ http://faq.mrtg.org Homepage http://www.mrtg.org WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
