YMMV, but ".iso.org.dod.internet.mgmt.mib-2.transmission.ds3.dsx3TotalTable.dsx3TotalEntry", aka .1.3.6.1.2.1.10.30.8.1, is probably a good part of the SNMP transmission MIB to go through. I monitor "Target[$router.$cardcode.$userslot.$port.11]: 1.3.6.1.2.1.10.30.6.1.2.$ifIndex&1.3.6.1.2.1.10.30.7.1.3.$ifIndex.$interval:[EMAIL PROTECTED]" (and other related OIDs) on DS3s coming into my various Riverstone routers, with great results. This shows me the number of blips (errored seconds in this case) in the "current" five-minute period and previous fifteen-minute period. It's not the world's most accurate, because I can't synchronize MRTG to the DS1/DS3 fifteen minute interval. The "current" five-minute period is semi-cumulative in this scenario, so in a succession of four polling intervals I might miss the tail end of an interval but catch less than the first five minutes, then catch another five minutes adding in, then catch another five minutes adding in, then miss the tail end of the interval while catching a portion of the next interval. By polling the previous interval (I set $interval to 1) three times, I at least get a history of full fifteen minutes' worth of counters at that point.
Pete Templin Senior Staff Engineer TexLink Communications (210) 892-4183 [EMAIL PROTECTED] -----Original Message----- From: Zeeshan Ahmed [mailto:[EMAIL PROTECTED] Sent: Friday, September 19, 2003 3:58 PM To: MRTG Mailinglist Subject: [mrtg] monitoring the "Unavailable Secs" of Serial Interface that has E3 card on Cisco ROuter I want to monitor the "Unavailable Secs" of my Serial Interface that has E3 card on Cisco ROuter 7204 VXR. I can see the Unavailable Secs of my interface by the command sh controllers serial 4/0 and I get following out put Total Data (last 78 15 minute intervals): 0 Line Code Violations, 0 P-bit Coding Violation, 0 C-bit Coding Violation, 0 P-bit Err Secs, 0 P-bit Sev Err Secs, 0 Sev Err Framing Secs, 44 Unavailable Secs, 0 Line Errored Secs, 0 C-bit Errored Secs, 0 C-bit Sev Err Secs how can i graph the parameters given in the out put,especially I am concerned with Unavailable Secs. Regards Zeeshan Ahmed -- Unsubscribe mailto:[EMAIL PROTECTED] Archive http://www.ee.ethz.ch/~slist/mrtg FAQ http://faq.mrtg.org Homepage http://www.mrtg.org WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi -- Unsubscribe mailto:[EMAIL PROTECTED] Archive http://www.ee.ethz.ch/~slist/mrtg FAQ http://faq.mrtg.org Homepage http://www.mrtg.org WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
