Thankyou BOB & all. The problem was resolve.
Regards, Rikunj ----- Original Message ----- From: "Bob Love" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Sunday, November 02, 2003 1:31 AM Subject: [mrtg] Re: Incorrect Low value graph > > I am expecting much higher values on graphs. > > This Interface is supposed to flow at the rate of 1.5 Mb the graphs shows > > 300 kb. > > > MaxBytes[CISCO]: 150000 > > 150000 is too low for an interface with a T1 on it - remember you divide by > 8 not 10. > > T1 = 1544000 = MaxBytes 193000 > > It doesn't hurt to leave a little room in MaxBytes especially a link that > peaks frequently. I'd use 200000 for this if I were you. > > MaxBytes is only used, to ignore "glitches" - i.e. make sure you don't get > any 8mbps glitches on a T1 due to an erroneous reading. You don't need to > (or shouldn't, in my experience) set it to *exactly* the maximum you > expect - a little headroom doesn't hurt. > > Regards > > Bob > > > -- > Unsubscribe mailto:[EMAIL PROTECTED] > Archive http://www.ee.ethz.ch/~slist/mrtg > FAQ http://faq.mrtg.org Homepage http://www.mrtg.org > WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi > > -- Unsubscribe mailto:[EMAIL PROTECTED] Archive http://www.ee.ethz.ch/~slist/mrtg FAQ http://faq.mrtg.org Homepage http://www.mrtg.org WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
