Hello List! I had SNMP working on my 2620. The unit only had 2 ethernet interfaces in it which connected to my fiber transceiver. I had MRTG working just fine. And I also use STG traffic grapher to check my router as well. After I installed the WIC in the 2620 I am no longer able to get data via SNMP. I have checked the Cisco config and made sure that snmp was still enabled and it is. So I shut the router down, removed the WIC and rebooted the router. And then SNMP was working again.
Has anyone seen this problem before? Is there some mystery setting that I'm missing. I know this is more of a Cisco question. Since MRTG is working fine with just the 2 interfaces. Any info you can give me would be GREATLY appreciated!! Nate -- Unsubscribe mailto:[EMAIL PROTECTED] Archive http://www.ee.ethz.ch/~slist/mrtg FAQ http://faq.mrtg.org Homepage http://www.mrtg.org WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
