On Thu, 12 Feb 2004, Bigelow, Andrea L. wrote: > I'm using SNMP2 to monitor a network of Cisco devices, and on every Cisco > device I'm monitoring, I'm unable to get utilization graphs for any of the > Tunnel(X) interfaces. Is there a specific OID I need to use for these?
They work fine for me and are detected automatically by MRTG. See if they may be detected but commented out in the mrtg.cfg for some reason. MRTG will usually pick up all interfaces and comment out with reason those that the script determines should not be displayed. Also note that Cisco sets the default bandwidth of tunnels to 9 kbits/s which MRTG will pick up and set as the maximum speed. So change the router config to put something reasonable there or the graphs will generate but not be very interesting. :-) -- Jay Hennigan - CCIE #7880 - Network Administration - [EMAIL PROTECTED] WestNet: Connecting you to the planet. 805 884-6323 WB6RDV NetLojix Communications, Inc. - http://www.netlojix.com/ -- Unsubscribe mailto:[EMAIL PROTECTED] Archive http://www.ee.ethz.ch/~slist/mrtg FAQ http://faq.mrtg.org Homepage http://www.mrtg.org WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
