Thanks Steve, That help a lot, my problem was fixed and everything is a go!
Thanks again, Jon -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of [EMAIL PROTECTED] Sent: Friday, April 09, 2004 5:55 PM To: Jon Ha Cc: mrtg Subject: [mrtg] Re: routers2.cgi problem Quoting Jon Ha <[EMAIL PROTECTED]>: > great there but when I tried to mimic the exact same setup on a Windows 2000 > Server I am unable to generate any graphs with routers2. I notice the graphs There is a separate mailing list and discussion forum for routers2.cgi problems, see the pages on http://www.steveshipway.org/software/ It sounds as if you have your iconurl, graphpath, graphurl settings incorrect in your routers2,conf file, or maybe incorrect permissions on the graphpath folder. If you go to the configuration verification page http://yourserver/cgi-bin/routers2.pl?page=verify then it will test for many common errors. Steve ------------------------------------------------- This mail sent through University of Auckland http://www.auckland.ac.nz/ -- Binary/unsupported file stripped by Ecartis -- -- Err : No filename to use for decode, file stripped. -- Type: application/pgp-keys -- Desc: PGP Public Key -- Unsubscribe mailto:[EMAIL PROTECTED] Archive http://www.ee.ethz.ch/~slist/mrtg FAQ http://faq.mrtg.org Homepage http://www.mrtg.org WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi -- Unsubscribe mailto:[EMAIL PROTECTED] Archive http://www.ee.ethz.ch/~slist/mrtg FAQ http://faq.mrtg.org Homepage http://www.mrtg.org WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
