I've got a 6MB DS3 on a Cisco 3725, and some of the values I've been getting back don't look right-
Here's what's at the bottom of the graph- "Max In: 100.1 kB/s (1.8%) Average In: 9202.0 B/s (0.2%) Current In: 42.4 kB/s (0.8%) Max Out: 26.0 kB/s (0.5%) Average Out: 3040.0 B/s (0.1%) Current Out: 8115.0 B/s (0.1%)" I'm not sure why the average in is 9202K- is this 9.2 megs? (maybe I just haven't had enough coffee yet) The 5526.2 isn't right- but it's higher- the actual bandwidth available top end configured on the router is the ' dsu bandwidth 44210' that Bell South had me put in- They control the speed down to 6 MB on their end to meet our SLA. Here's the relevant section of the config: built by cfgmaker ### Interface 5 >> Descr: 'Serial1/0' | Name: 'Se1/0' | Ip: '68.152.xxx.54' | Eth: '' ### Target[xxx.xxx.83.253_Serial1_0]: \Serial1/0:[EMAIL PROTECTED]: SetEnv[xxx.xxx.83.253_Serial1_0]: MRTG_INT_IP="68.152.158.54" MRTG_INT_DESCR="Serial1/0" MaxBytes[xxx.xxx.83.253_Serial1_0]: 5526250 Title[xxx.xxx.83.253_Serial1_0]: Serial1/0 -- acsbr3725 PageTop[xxx.xxx.83.253_Serial1_0]: <H1>Serial1/0 -- acsbr3725</H1> <TABLE> <TR><TD>System:</TD> <TD>acsbr3725 in </TD></TR> <TR><TD>Maintainer:</TD> <TD></TD></TR> <TR><TD>Description:</TD><TD>Serial1/0 </TD></TR> <TR><TD>ifType:</TD> <TD>frame-relay (32)</TD></TR> <TR><TD>ifName:</TD> <TD>Se1/0</TD></TR> <TR><TD>Max Speed:</TD> <TD>5526.2 kBytes/s</TD></TR> <TR><TD>Ip:</TD> <TD>xxx.xxx.158.54 ()</TD></TR> </TABLE> Tim Reimers Asheville City Schools IT tim.reimers(at)asheville(dot)k12(dot)nc(dot)us 828-255-5304x374 http://www.gordano.com - Messaging for educators. -- Unsubscribe mailto:[EMAIL PROTECTED] Archive http://www.ee.ethz.ch/~slist/mrtg FAQ http://faq.mrtg.org Homepage http://www.mrtg.org WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
