----- Original Message ----- From: "David Ziemba" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Tuesday, June 08, 2004 4:24 PM Subject: [mrtg] Re: can't get traffice from sub-interface of router
> We are monitoring an atm interface on a subinterface aal5-layer, looks > like a similar setup anyway: > > https://openfire.coloradocollege.edu/cgi-bin/routers2.cgi?uopts=t&rtr=loo_7206.cfg Hi Dave, on your monitoring page there's a CAT4912, but you don't have a sub int on this device. So I tryed to get stats of a Gigabit sub interface (like Gi2.1) but when i run cfgmaker the sub interface doesn't appear with the fisical interfaces. I can't undestand if it's a problem of MRTG or it's a simple OID problem, because on real router like my GW (a 7206VXR NPE-400) I haven't problem, all fisical and sub interfaces are listed in config file without problem. Did you (or someone else) get the same problem? On Cisco there is the "SNMP Navigator", there are all the OID and MIBs to get everything from Cisco devices, but it's a real mess to use! :( Thank's! Ste. -- Unsubscribe mailto:[EMAIL PROTECTED] Archive http://www.ee.ethz.ch/~slist/mrtg FAQ http://faq.mrtg.org Homepage http://www.mrtg.org WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
