U could monitor the interfaces on their real IP address,
'n then use the aggregate traffic analysis [target] 1st_int + 2nd_int.
So it should work.
Only a suggestion... the mrtg server should be on the same IP LAN
(or VLAN) of the routers dued to routing problems that can occur.
Bye,
Ste.
----- Original Message -----
From: "Mordechai T. Abzug" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Friday, August 20, 2004 9:18 AM
Subject: [mrtg] cfgmaker and VRRP/HSRP?
>
> Is there any way to get MRTG's cfgmaker to skip VRRP and/or HSRP
> interfaces? We tend to set up VRRP/HSRP with a "real" IP for each
> device and an extra IP held by the current "live" device. When I run
> cfgmaker with --ifref=ip, often, the "virtual" IP is picked on the
> currently live device instead of the real one, and the real one is
> skipped because of the underlying interface instance is the same.
> This means that in the event of a failover, the config is wrong. I've
> been fixing the config manually; is there a better way?
>
> Thanks!
>
> - Morty
>
> --
> Unsubscribe mailto:[EMAIL PROTECTED]
> Archive http://www.ee.ethz.ch/~slist/mrtg
> FAQ http://faq.mrtg.org Homepage http://www.mrtg.org
> WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
>
>
--
Unsubscribe mailto:[EMAIL PROTECTED]
Archive http://www.ee.ethz.ch/~slist/mrtg
FAQ http://faq.mrtg.org Homepage http://www.mrtg.org
WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
