Hi everyone, I have MRTG polling a Riverstone router for CPU utilisation. I have the OID and doing an snmpget, I get the correct value so I know the OID is correct. I have created a cfg file and when MRTG runs it, I get no error. However the resulting graph shows zero values.
I am looking in the log and I see zero value entered everywhere except the first line which contains the correct value. But when MRTG is run again, this value does not get carried over. The latest poll just overwrites this first line. I hope you understand what I am describing! Here is the first few lines of the log: 1102500008 4 4 <---- this is the correct value but graph shows zero 1102500008 0 0 0 0 1102499870 0 0 0 0 1102499700 0 0 0 0 1102499400 0 0 0 0 etc... I have another cfg file for Memory utilisation on the same router and this works fine. Has anyone had this problem before where the correct value is polled but the log file does not update correctly? Thank you for any help. Best regards, Gareth The content of this e-mail and any attachment is private and may be legally privileged. If you are not the intended recipient, any use, disclosure, copying or forwarding of this e-mail and/or its attachments is unauthorised. If you have received this e-mail in error please notify the sender by e- mail and delete this message and any attachments immediately from this system. Kingston Communications (HULL) PLC is a public limited company incorporated in England and Wales with registration number 02150618 and whose registered office is at 37 Carr Lane, Hull HU1 3RE 118 288 - Kingston UK Directory Enquiries. Each call costs 35p* for up to 3 searches, calls from mobiles and other networks may vary. *As at 01/03/04. -- Unsubscribe mailto:[EMAIL PROTECTED] Archive http://www.ee.ethz.ch/~slist/mrtg FAQ http://faq.mrtg.org Homepage http://www.mrtg.org WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
