I managed to get MRTG version 2.12.2 up and running with some initial issues. I am having it generate me the usual MRTG reports, however, for each of the 24 ports, I just get "Traffic Analysis for 1 --"
I would like to get more descriptive names for each port. I can hand edit the config file, but the next time I make edits in MRTG and re-run it, they of course will be written over. I am pretty new to SNMP and MRTG, is there something in the switch I set so that a more descriptive name can show up in MRTG? As it is now, I am getting this: ### Interface 1 >> Descr: '' | Name: 'g1' | Ip: '' | Eth: '' ### Target[my.switch.ip.address_1]: 1:[EMAIL PROTECTED]: SetEnv[my.switch.ip.address_1]: MRTG_INT_IP="" MRTG_INT_DESCR="" MaxBytes[my.switch.ip.address_1]: 12500000 Title[my.switch.ip.address_1]: Traffic Analysis for 1 -- PageTop[my.switch.ip.address_1]:Traffic Analysis for 1 -- -- ------------------------------------------------------------- Scott Haneda Tel: 415.898.2602 <http://www.newgeo.com> Novato, CA U.S.A. -- Unsubscribe mailto:[EMAIL PROTECTED] Archive http://lists.ee.ethz.ch/mrtg FAQ http://faq.mrtg.org Homepage http://www.mrtg.org WebAdmin http://lists.ee.ethz.ch/lsg2.cgi
