On Fri, 2006-07-14 at 10:32 -0400, Geba, Scott wrote: > I have read through the manuals, and went back as far as I could with > the list so I hope I didn't miss this. I'm using MRTG/RRDTool to graph > some routers. Every one of my routers has numerous gige interfaces and > at least 2 10Gigabit interfaces on them and active. Is there any way to > have the correct MaxBytes associated to them automatically without > having to go in and replace them in the cfg? I just started using MRTG > and haven't gotten too deep into script creating or anything. > > > One more thing, I think I already know the answer, but I'll ask anyway, > you can just ignore it... Quite a few of my routers have port channels > with 3 10GigE links in them, is there a way to automate MaxBytes on > these, or is find and replace my friend? Thanks in advance!
cfgmaker should pick them up correctly if you use snmp v2 or v3. What are you seeing for maxbytes? Does it match snmpwalk ifSpeed ? If ifSpeed is reporting incorrectly, then you can change that using the bandwidth interface configuration command on the router and re-run cfgmaker... -- Daniel J McDonald, CCIE #2495, CNX, CISSP #78281 Austin Energy gpg Key: http://austinnetworkdesign.com/pgp.key Key fingerprint = B527 F53D 0C8C D38B DCC7 901D 2F19 A13A 22E8 A76A -- Unsubscribe mailto:[EMAIL PROTECTED] Archive http://lists.ee.ethz.ch/mrtg FAQ http://faq.mrtg.org Homepage http://www.mrtg.org WebAdmin http://lists.ee.ethz.ch/lsg2.cgi
