Hello, I'm revisiting MRTG after a while away from it, and am having an issue getting the results I want. I'm probably missing something, but after reading through the documentation and doing some web searches I'm still not getting the results I desire. I see some information about Cisco VLAN interfaces, but I don't see how to apply them in this case.
Here's the situation: FortiGate 200A MRTG 2.16.0 on a CentOS Linux installation The FortiGate reports 8 interfaces to an SNMP query - interfaces 1 - 5 are physical interfaces of type ethernetCsmacd(6). Interfaces 6 - 8 are VLAN interfaces of type l2vlan(135) operating off of physical interface 4. What I want is separate graphing of the traffic on the VLAN interfaces. The counters are there in an SNMP query, but when I try to add the interfaces in MRTG the device information appears under the last listed physical interface, and there is only one set of graphs for all devices listed on that page. I believe from the filename of the graphic that the graphs are for the physical interface. I've tried editing the mrtg.cfg file without luck. I've tried removing all the physical interfaces from the configuration file (nothing generated), removing the ifType stanza for the virtual interface, using ifInOctets.8 as part of the Target string, removing all but the bare-bones information as shown on http://oss.oetiker.ch/mrtg/doc/mrtg-reference.en.html. No go on any of them. Any ideas? Thank you, Michael Michael Silver, Network Administrator Parkland Regional Library 5404 56 Avenue Lacombe, AB T4L 1G1 Phone: 403.782.3850 Fax: 403.782.4650 http://www.prl.ab.ca/ [EMAIL PROTECTED] _______________________________________________ mrtg mailing list [email protected] https://lists.oetiker.ch/cgi-bin/listinfo/mrtg
