DD-WRT is custom/opensource firmware for a variety of routers/wireless access points.
I happen to be running DD-WRT on a Linksys WRT54G access point. (WAN + 4 LAN +Wireless). The DD-WRT firmware supports SNMP, but as mentioned I want to monitor how much WAN traffic each IP on the LAN is using? Doable? Cheers Al From: Christopher Noyes [mailto:[EMAIL PROTECTED] Sent: Sunday, 3 August 2008 2:03 p.m. To: Al Grant Subject: Re: [mrtg] MRTG What is a DD-WRT? More than likely you cannot monitor an IP address; you should be able to monitor a port on a switch/router and (using MRTG's defaults) get a measurement of in/out traffic rate. So, is this DD-WRT an SNMP manageable device? -CN Computer Sciences Corporation Registered Office: 3170 Fairview Park Drive, Falls Church, Virginia 22042, USA Registered in Nevada, USA No: C-489-59 ---------------------------------------------------------------- This is a PRIVATE message. If you are not the intended recipient, please delete without copying and kindly advise us by e-mail of the mistake in delivery. NOTE: Regardless of content, this e-mail shall not operate to bind CSC to any order or other contract unless pursuant to explicit written agreement or government initiative expressly permitting the use of e-mail for such purpose. ---------------------------------------------------------------- [EMAIL PROTECTED] wrote: ----- To: <[email protected]> From: "Al Grant" <[EMAIL PROTECTED]> Sent by: [EMAIL PROTECTED] Date: 08/02/2008 06:03PM Subject: [mrtg] MRTG Hi Folks, A bit of a newbie here. Could someone please tell me if I can monitor how much traffic is being used monthly by a IP on the LAN using DD-WRT and MRTG? Thanks in advance, -Al _______________________________________________ mrtg mailing list [email protected] https://lists.oetiker.ch/cgi-bin/listinfo/mrtg =
_______________________________________________ mrtg mailing list [email protected] https://lists.oetiker.ch/cgi-bin/listinfo/mrtg
