Hello, I had the same problem too, and it turned out that... CPU usage is so low (~1%) that I didn't see it on the graph. You can check that manually by invoking snmpwalk with your OID and see CPU rate
2008/11/18 nangineni praneeth <[EMAIL PROTECTED]>: > Thanks a lot for your help.........Yes i did try your suggestion by > appending 0 at the end and it was giving out errors like > > Target[graham][_IN_] did not eval into defined data > Target[graham][_out_]did not eval into defined data > > Yet its creating the graphs but with no data...........I cant understand > what mistake i did.......If the cpu OID is wrong....then i did monitor a > cisco 2811 series router but the graphs were blank too.........Do i need to > add any code to my cfg file and i am inserting my cpu load config at the end > of cfg file..........I am using a windows xp machine with only one processor > > Regards > Venkat........ > > --- On Tue, 11/18/08, Steve Shipway <[EMAIL PROTECTED]> wrote: > > From: Steve Shipway <[EMAIL PROTECTED]> > Subject: RE: [mrtg] MRTG and blank cpu graphs...........please help > To: "'[EMAIL PROTECTED]'" <[EMAIL PROTECTED]>, "'[email protected]'" > <[email protected]> > Date: Tuesday, November 18, 2008, 10:16 AM > > Are you sure the OID is correct? It is possible that you should be using: > > > > Target[graham]:1.3.6.1.2.1.25.3.3.1.2.0&1.3.6.1.2.1.25.3.3.1.2.0:[EMAIL > PROTECTED] > > > > Often you need the .0 suffix to the OID. Check your MRTG output when it > runs – do you get any SNMP errors? > > > > Steve > > > > ________________________________ > > From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] > On Behalf Of nangineni praneeth > > Hello everyon...I am a complete newbie to mrtg............I was able to > monitor the interface statistics..........I wanted to the monitor the cpu > load on a windows xp machine.........MRTG could draw the graphs but the > graphs were blank.......the average cpu utilization and maximum and current > cpu utilization shows a value of zero........... > > This is cfg file i used for cpu > > Target[graham]:1.3.6.1.2.1.25.3.3.1.2&1.3.6.1.2.1.25.3.3.1.2:[EMAIL PROTECTED] > > > > _______________________________________________ > mrtg mailing list > [email protected] > https://lists.oetiker.ch/cgi-bin/listinfo/mrtg > > _______________________________________________ mrtg mailing list [email protected] https://lists.oetiker.ch/cgi-bin/listinfo/mrtg
