Sorry for pulling up an old thread again.. 2008/3/20 Daniel J McDonald <[email protected]>: > > On Tue, 2008-03-18 at 16:37 -0600, Karina Gómez wrote: >> ifInOctets.2&ifOutOctets.2:[email protected]:::::2 >> >> isn't activated with that last 2 ? > > Yes, but until 2.15.2, if it detected from ifHighSpeed that the 64 bit > counters were not used, then it would drop back to snmp V1 and use > ifInOctets and ifOutOctets. > > In 2.15.2, I introduced a change to poll using snmp v2, but force the > use of ifInOctets and ifOutOctets. The change in behavior is signaled > by the NoHC[] directive. That was needed for snmp v3 boxes, since you > can't just fall back from v3 to v1. But it also works for snmp V2 > low-speed interfaces.
I have some Alcatel (Lucent?) OmniSwitch 6850. They have ifHC*Octets for all interfaces, but 1gig ports have: $> snmpwalk -v2c -c public kp-sw-01 ifSpeed.1001 IF-MIB::ifSpeed.1001 = Gauge32: 1000000000 $> snmpwalk -v2c -c public kp-sw-01 ifHighSpeed.1001 IF-MIB::ifHighSpeed.1001 = Gauge32: 0 $> snmpwalk -v2c -c public kp-sw-01 ifHCInOctets.1001 IF-MIB::ifHCInOctets.1001 = Counter64: 203087599517594 $> snmpwalk -v2c -c public kp-sw-01 ifHCInOctets.1001 IF-MIB::ifHCInOctets.1001 = Counter64: 203087630531445 $> snmpwalk -v2c -c public kp-sw-01 ifHCInOctets.1001 IF-MIB::ifHCInOctets.1001 = Counter64: 203087661917295 I want to use the ifHCInOctets because they are 64bit. Too bad the ifHighSpeed is not set. ifHCInOctets is obviously there. Just to get the full picture, I include the values for 10gig ports as well: $> snmpwalk -v2c -c public kp-sw-01 ifSpeed.1025 IF-MIB::ifSpeed.1025 = Gauge32: 4294967295 $> snmpwalk -v2c -c public kp-sw-01 ifHighSpeed.1025 IF-MIB::ifHighSpeed.1025 = Gauge32: 10000 $> snmpwalk -v2c -c public kp-sw-01 ifHCInOctets.1025 IF-MIB::ifHCInOctets.1025 = Counter64: 4832849933769282 $> snmpwalk -v2c -c public kp-sw-01 ifHCInOctets.1025 IF-MIB::ifHCInOctets.1025 = Counter64: 4832850414024483 $> snmpwalk -v2c -c public kp-sw-01 ifHCInOctets.1025 IF-MIB::ifHCInOctets.1025 = Counter64: 4832851374149276 Would it be able to make cfgmaker support this scenario as well? Best regards Hakan Lindholm _______________________________________________ mrtg mailing list [email protected] https://lists.oetiker.ch/cgi-bin/listinfo/mrtg
