Hi Steve,
I hate to be a pain but, I'm getting errors...
When I use '*300' I get:
ERROR: Target[genoa.err][_IN_] ' $target->[0]{$mode} *300:' (eval):
syntax error at (eval 6) line 1, near "300:"
Original target line:
Target[genoa.err]: ifInErrors.1&ifOutErrors.1:redr...@genoa:
Modified target line:
Target[genoa.err]: ifInErrors.1&ifOutErrors.1:redr...@genoa*300:
So, I tried Factor[], I added:
Factor[genoa.err]: 300
and now I get:
ERROR: CFG Error Unknown Option "factor[genoa.err}" on line 41 or above.
If it matters, I'm running mrtg version 2.10.13
Thanks
>>> Steve Shipway <[email protected]> 4/12/2010 3:29 PM >>>
>1) Yes, 'noo' will remove the line and the legend.
>
>2) You should remove the 'perminute' if you're multiplying by 300 to get 'per
>5min' as it is no longer relevant. You should probably also >replace your
>Y-Axis label or legend to indicate the values are a 5min count.
>Target[$target_name]:
>ifInErrors.$if_index&ifOutErrors.$if_index:$router_connect * 300
>or
>Factor[$target_name]: 300
>
>Steve
________________________________________
>>1) My existing Options[] line says:
>> Options[]: growright,nopercent,perminute,unknaszero
>>...will the noo remove the Output Legend also?
>>
>>2) The Target[] line (in the interfaces file) says:
>> Target[$target_name]:
>> ifInErrors.$if_index&ifOutErrors.$if_index:$router_connect
>>
>> a) With the 'perminute' option above, would the '* 300' work?
>> b) Where would I add the '* 300'?
>>> 1) Just add the 'noo' option to the Options[] line
>>> 2) Multiply Target by 300 should do it (either use Factor[] or '* 300' in
>>> the Target line)
>>>> 1) only graph ifInErrors and NOT ifOutErrors?
>>>> 2) graph actual 5min error count and NOT a 5min average?
===================
Please use caution when driving through work zones.
Find more information about work zone safety at
www.txdot.gov/safety/tips/work_zones.htm
_______________________________________________
mrtg mailing list
[email protected]
https://lists.oetiker.ch/cgi-bin/listinfo/mrtg
