I'm running into a problem with cfgmaker on Adtran Total Access products, new with MRTG 2.17.1 and high speed counter fallback.
The PPP and HDLC interface types return a blank value for speed. Cfgmaker debug snippet below: --base: snmpget xxx@yyy:::::2:v4only for ifHighSpeed.18 -> Mb/s --base: snmpget xxx@yyy:::::2:v4only for ifHCInOctets.18 -> --base: check for HighspeedCounters? failed ... Dropping back to V1 But then the output shows as ### Interface 18 >> Descr: 'ppp-2' | Name: 'ppp 2' | Ip: '172.31.255.2' | Eth:''### ### The following interface is commented out because: ### * has a speed of which makes no sense If, however, you manually snmpget the v1 low speed counter it returns a sane value. Failed high-speed: $ snmpget -v 2c -c xxx yyy ifHighSpeed.18 Error in packet Reason: (noSuchName) There is no such variable name in this MIB. Failed object: IF-MIB::ifHighSpeed.18 Successful low-speed: $ snmpget -v 2c -c xxx yyy ifSpeed.18 IF-MIB::ifSpeed.18 = Gauge32: 1536000 So it appears that either the result from ifHighSpeed is not being correctly interpreted or the cfgmaker script fails to poll and/or use the ifSpeed value. Fast ethernet interfaces correctly report the high speed in Mbps, see below. snmpget -v 2c -c xxx yyy ifHighSpeed.5 IF-MIB::ifHighSpeed.5 = Gauge32: 100 Contact info below. I can make a lab device available online should this be helpful. -- Jay Hennigan - CCIE #7880 - Network Engineering - [email protected] Impulse Internet Service - http://www.impulse.net/ Your local telephone and internet company - 805 884-6323 - WB6RDV _______________________________________________ mrtg mailing list [email protected] https://lists.oetiker.ch/cgi-bin/listinfo/mrtg
