On Wednesday 29 August 2018 16:54:03 Geoffrey Barton via mseide-msegui-talk wrote: > > > Does a manual 'Target'-'Reset' in > > MSEide change the situation? > > No, I think because, if indeed the Target-Reset triggers a hardware reset, > the processor then immediately boots from flash and runs again. > Does a MSEide 'Target'-'Interrupt' actually stop the target? AFAIK running st-util without the -n parameter resets the board. MSEide should restart st-util before downloading or after a reset. Is there a difference in downloading the first time after MSEide start?
The tutorial https://github.com/texane/stlink/blob/master/doc/tutorial.md writes about connecting the target by "(gdb) target extended localhost:4242". You could try to change 'Project'-'Options'-'Debugger'-'Target'-'Target connection' to "extended localhost:4242". There is a stlink bugtracker in case you find a problem in st-util: https://github.com/texane/stlink/issues Martin ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ mseide-msegui-talk mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/mseide-msegui-talk
