If you want to do that, you have put a serial resistor between the 5
Volts signal and the I/O pin of the MSP to limit the current inside the
clamp diode to few milliamps.
Bernard MONDAN
___________________________________________________
Peter Mueller wrote:
Hi,
for a prototype I want to connect the msp with some i/o signals from
an 5V supplied i/o board. Is it possible to use 5V for the msp (I
know there are chips do do 3.3V to 5V signal conversion)?
Thanks,
Peter
-------------------------------------------------------
SF.Net email is sponsored by Shop4tech.com-Lowest price on Blank Media
100pk Sonic DVD-R 4x for only $29 -100pk Sonic DVD+R for only $33
Save 50% off Retail on Ink & Toner - Free Shipping and Free Gift.
http://www.shop4tech.com/z/Inkjet_Cartridges/9_108_r285
_______________________________________________
Mspgcc-users mailing list
Mspgcc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/mspgcc-users
