On Fri, Dec 09, 2011 at 10:09:38AM +0100, Bob von Knobloch wrote: > Farnell are newly promoting an MSP430 board with FRAM - MSP-EXP430FR5739 > > The data sheet says: > > "The MSP430FR5739 device on the experimenter board can be powered and > debugged via the integrated ezFET, or via TI Flash Emulation Tool, like > the MSP-FET430UIF." > > Do you know if mspdebug will drive it ezFET)?
Hi Robert, The MSP430FR5739 is supported since version 0.17. I've heard reports of people using this board successfully with mspdebug, via the rf2500 driver. However, you must use the "load" command rather than "prog" for programming (prog is equivalent to erase followed by load -- FRAM doesn't need to be erased, and the erase command isn't supported with these chips anyway). One other thing to be careful of is the JTAG fuse problem that can occasionally crop up. This is fixable via the BSL -- if you check the list archive, there was recently a discussion of this problem, possible causes and fixes. Cheers, Daniel -- D.L. Beer Engineering www.dlbeer.co.nz ------------------------------------------------------------------------------ Cloud Services Checklist: Pricing and Packaging Optimization This white paper is intended to serve as a reference, checklist and point of discussion for anyone considering optimizing the pricing and packaging model of a cloud services business. Read Now! http://www.accelacomm.com/jaw/sfnl/114/51491232/ _______________________________________________ Mspgcc-users mailing list Mspgcc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/mspgcc-users
