Could you provide a link to where you found the tweaked tusb3410 driver for mac?
Best regards, --------------------------------------- Sergio Campamá sergiocamp...@gmail.com On Apr 15, 2012, at 3:14 PM, Andy Turk wrote: > I'm pulling out my hair (and I don't have much to lose) trying to get > mspdebug to talk to a MSP-EXP430F5438 experimenter board through TI's > MSP-FET430UIF. Here's what I'm getting: > > $ MSPDEBUG_TI3410_FW=/opt/local/lib/mspdebug/ti_3410.fw.ihex mspdebug -d > /dev/tty*FET* uif > MSPDebug version 0.19 - debugging tool for MSP430 MCUs > Copyright (C) 2009-2012 Daniel Beer <dlb...@gmail.com> > This is free software; see the source for copying conditions. There is NO > warranty; not even for MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. > > Trying to open UIF on /dev/tty.MSP-FET430UIF26230... > Initializing FET... > FET protocol version is 20401000 > Configured for Spy-Bi-Wire > Set Vcc: 3000 mV > fet: FET returned error code 4 (Could not find device (or device not > supported)) > fet: command C_IDENT1 failed > fet: identify failed > Trying again... > Initializing FET... > FET protocol version is 20401000 > Configured for Spy-Bi-Wire > Sending reset... > uif: read error: Operation timed out > warning: fet: reset failed > uif: read error: Operation timed out > warning: fet: set VCC failed > uif: read error: Operation timed out > fet: command C_IDENT1 failed > fet: identify failed > $ > > Here's my setup: > > 1. The mac is running Lion (10.7.3) > 2. I've installed a tweaked TUSB3410 driver which creates the > /dev/tty.MSP-FET… device when the FET is plugged in via USB > 3. The 5438 experimenter board is plugged in via a ribbon cable to the FET > 4. SW1 (power selector) switch on the experimenter board is all the way left > in the "FET" position > 5. When the FET powers up, the red LED flashes and goes out, then the green > LED comes on solid > 6. As soon as mspdebug runs, the red LED on the FET flashes and then stays on > 7. The sticker on the back of the FET says v1.4a > > Unfortunately, I don't have access to a windows machine (at the moment) so I > haven't been able to check things out using official TI software. Suggestions > are welcomed and appreciated. > > Thanks, > > Andy > > ------------------------------------------------------------------------------ > For Developers, A Lot Can Happen In A Second. > Boundary is the first to Know...and Tell You. > Monitor Your Applications in Ultra-Fine Resolution. Try it FREE! > http://p.sf.net/sfu/Boundary-d2dvs2 > _______________________________________________ > Mspgcc-users mailing list > Mspgcc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/mspgcc-users ------------------------------------------------------------------------------ For Developers, A Lot Can Happen In A Second. Boundary is the first to Know...and Tell You. Monitor Your Applications in Ultra-Fine Resolution. Try it FREE! http://p.sf.net/sfu/Boundary-d2dvs2 _______________________________________________ Mspgcc-users mailing list Mspgcc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/mspgcc-users
