In my case, I believe I had to request "bypass mode" based on source/destination IP pairing.
On Wed, Sep 18, 2013 at 7:33 AM, Trevor Sullivan <[email protected]> wrote: > Thanks guys. Is there a way to configure the Riverbed devices to ignore > traffic to/from ConfigMgr site systems? I’m not familiar with the > configuration of these devices, so any insight would be appreciated.**** > > ** ** > > Cheers,**** > > Trevor Sullivan**** > > ** ** > > *From:* [email protected] [mailto: > [email protected]] *On Behalf Of *Kim Oppalfens > *Sent:* Tuesday, September 17, 2013 3:39 PM > > *To:* [email protected] > *Subject:* RE: [mssms] ConfigMgr 2012 & Riverbed**** > > ** ** > > Yups, one of our consultants hates these devices like hell.**** > > He spent hours on the blog post below before he could figure it out.**** > > ** ** > > *From:* [email protected] [ > mailto:[email protected] <[email protected]>] *On > Behalf Of *Dzikowski, Michael > *Sent:* 17 September 2013 18:47 > *To:* [email protected] > *Subject:* RE: [mssms] ConfigMgr 2012 & Riverbed**** > > ** ** > > I’ve seen this before… if not configured properly the compression stuff > breaks a lot of things… **** > > ** ** > > Content Distribution can break etc.**** > > ** ** > > > http://scug.be/sccm/2013/01/30/configmgr-2012-rtmsp1-and-riverbed-appliances-not-a-good-marriage-application-fails-during-osd-task-sequence-with-exit-code-16389-requestcontent-from-cas-failed-error-0x87d01202-a/ > **** > > ** ** > > ** ** > > *From:* [email protected] [ > mailto:[email protected] <[email protected]>] *On > Behalf Of *Trevor Sullivan > *Sent:* Tuesday, September 17, 2013 12:22 PM > *To:* [email protected] > *Subject:* [mssms] ConfigMgr 2012 & Riverbed**** > > ** ** > > Hey folks,**** > > ** ** > > Is anyone aware of any complications, of any sort, with Riverbed and > ConfigMgr 2012?**** > > ** ** > > Cheers,**** > > Trevor Sullivan**** > > ** ** > > ** ** > > ** ** > >
