Guys, I'm researching a way for a single Task Sequence to do both the Capture
of a source computer and the Restore to the Destination (LOCAL) computer the TS
is running from.
My thoughts are to run PSEXEC with the USMT command line...but I would like to
have the user state stored at the SMP.
So it would look something like this.
1. I create Computer Association for Source and Destination computer in
SCCM
2. TS is sent to Destination computer
3. TS is started on Destination computer
4. TS -
a. Capture User State on Source (How to make this happen?)
i. Request
State Store
ii. Set
OSDMigrateAdditionalCapture
iii. Capture
User State
iv. Release
State Store
b. Restore User State on Destination
i. Request
State Store
ii. Set
OSDMigrateAdditionalCapture
iii. Restore
User State
iv. Release
State Store
This e-mail is intended solely for the person or entity to which it is addressed
and may contain confidential and/or privileged information. Any review,
dissemination,
copying, printing or other use of this e-mail by persons or entities other than
the
addressee is prohibited. If you have received this e-mail in error, please
contact
the sender immediately and delete the material from any computer.
To unsubscribe send an email to: [email protected]
Hitachi Consulting Corporation, 14643 Dallas Parkway, Suite 800, Dallas, Texas
75254 (HCAD0411)
