I've been using this script very successfully in 2007 and now in 2012
http://myitforum.com/myitforumwp/2011/11/16/sccm-task-sequence-completion-email-notification/
I've modified it a bit to also show the serial number and Lenovo Model
information, but works like a charm!
(Kudos to Joe Clark!)
The first step in the Task Sequence will run the first script, to get the email
address to send to. Some of our techs don't care for the email and/or forget
that dialog will be presented and walk away, only to find out an hour later,
that the image is no further along, so i've added a 5 minute timeout to that
step and then tell it to continue on error, if no one clicks the OK or cancel
on the prompt.
The second script runs toward the end of the Task Sequence, just before our
Symantec client installs.
Good Luck.
Jim
> From: [email protected]
> Subject: [mssms] Build TS complete status should be emailed
> Date: Tue, 15 Jul 2014 15:27:29 +0530
> To: [email protected]
>
> Got a requirement that after build success or failure there should be an
> email sent to the local build engineer with the status.
>
> Has any one already done this???
>
>
> Sent from iPhone....sorry for typos
>
>
>
