Confirm the package ID mentioned is still an app/package that actually exists and not one that has been deleted but the DP still has in WMI. Also check to see if there’s a corresponding <packageID>.INI file for it in SCCMContentLib/PkgLib on the DP.
From: [email protected] [mailto:[email protected]] On Behalf Of George Salmaniw Sent: Thursday, January 29, 2015 3:59 PM To: [email protected] Subject: Re: [mssms] SCCM 2012R2 Content distribution warnings mismatch between Content Status and Distribution Point Configuration Status smsdpmon.log displays the following for the package in question: Report status message 0x4000094C to MP SMS_Distribution_Point_Monitoring 1/24/2015 5:18:38 PM 7084 (0x1BAC) Status message has been successfully sent to MP from remote DP SMS_Distribution_Point_Monitoring 1/24/2015 5:18:38 PM 7084 (0x1BAC) So I see the error and will investigate, however there has been no updates to the log file since 1/24/2015 ... could this monitoring be on a weekly schedule? G On Thu, Jan 29, 2015 at 2:08 PM, Sean Pomeroy <[email protected]<mailto:[email protected]>> wrote: What are the errors in the smsdpmon.log on the DP? On Thu Jan 29 2015 at 2:05:16 PM George Salmaniw <[email protected]<mailto:[email protected]>> wrote: Further information just came to light. Noticed that the two DPs that are reporting failures, and therefore bringing this distribution content mismatch to light, are the only DPs to have Content Validation enabled. How significant is these error messages? G On Thu, Jan 29, 2015 at 1:54 PM, George Salmaniw <[email protected]<mailto:[email protected]>> wrote: Using SCCM 2012R2 CU3 and am seeing the following behaviour when monitor content distribution on a specific distribution point: Under Monitoring / Distribution Status / Content Status / <Application> status shows Content was distributed to distribution point Under Monitoring / Distribution Status / Distribution Point Configuration Status / Distribution Point Name / Details the same Application [same Package ID] shows error with message Failed to validate package on distribution point … The only difference I am noticing is on the timestamps for each. Under Content Status its last update was January 28, 2015. Under Distribution Point Configuration Status its last update for the particular package was January 24, 2015. Is the reason for the content mismatch warnings due to the Distribution Point Configuration Status not being updated to the current status? Is there a way of manually updating Distribution Point Configuration Status for a particular DP? Assistance is appreciated, G
