Right, tried the share and then went back and its refreshed.
Thanks for the tip. From: [email protected] [mailto:[email protected]] On Behalf Of Andreas Hammarskjöld Sent: Freitag, 27. Februar 2015 11:06 To: [email protected] Subject: RE: [mssms] Multiple users accessing the MDT DB I think you have to refresh further up in the console? From: [email protected] <mailto:[email protected]> [mailto:[email protected]] On Behalf Of Roland Janus Sent: den 27 februari 2015 10:26 To: [email protected] <mailto:[email protected]> Subject: [mssms] Multiple users accessing the MDT DB Is there advice on handle that properly? Ive started the console twice, with the same user, added a dummy entry on the first console. One issue is that the 2nd console wouldnt show that entry. Refresh isnt doing anything. I had to close and open again. The same happens of course when entries are changed or added. Unless the other console is closed and open again it wouldnt show. Those two even showed different values for the same ID, depending on where it was changed. That of course can cause inconsistency and entries being overwritten. I dont plan to use the console anyway, but a powershell based GUI, with the MDT-module from Niehaus. Would I ran into the same problems, or how do I handle multiple users then? -Roland
