Usually you have to use the raid card utilities in whatever OS you are running to tell the controller to rebuild the array on the new disk.
Jamy -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] Sent: Wednesday, November 28, 2001 4:14 PM To: MSWinNT Discussions Subject: Re: quick question about raid (rephrase) It does find the hard drive, but does not automatically add it to the RAID array. At 01:11 PM 11/28/2001 -0800, you wrote: >Good question. I think you have to do something special. I am using an >Adaptec 3200 RAID card and it says if I have to replace or add an hard >drive, I have to do something (just a few clicks on the pull down >menus). It does not find it automatically > >Been running RAID1 and RAID5 for a few years now and have not had a hard >drive failure yet. (knock on wood.) > >At 02:55 PM 11/28/2001 -0600, you wrote: >>I have a quick question about raid. If I add a new drive will the drive >>just be raided or do I have to do something special? >> >>Are there any good articles out there about raid? >> >>TIA, >>Brett >> >>------ >>You are subscribed as [EMAIL PROTECTED] >>Archives: http://www.swynk.com/sitesearch/search.asp >>To unsubscribe send a blank email to [EMAIL PROTECTED] > > > >------ >You are subscribed as [EMAIL PROTECTED] >Archives: http://www.swynk.com/sitesearch/search.asp >To unsubscribe send a blank email to [EMAIL PROTECTED] ------ You are subscribed as [EMAIL PROTECTED] Archives: http://www.swynk.com/sitesearch/search.asp To unsubscribe send a blank email to [EMAIL PROTECTED] ------ You are subscribed as [email protected] Archives: http://www.swynk.com/sitesearch/search.asp To unsubscribe send a blank email to [EMAIL PROTECTED]
