> 1) You said the GFX9000 can be connected in any cartridge slot. Does it
> means I need not to modify the internal hardware of my msx?
> Simply by connecting the cartridge the gfx is enabled?
> Can I remove it from my computer, go to a friend and connect in
> his computer?
Yes
> 2) If the previous is true, what is the output of the cartridge? Does
> it have a RGB connector? A RF connector? Can I plug it on my
> PAL-M TV or does it require a NTSC TV or a PAL TV?
You need monitor with Scart connector. It is also possibble to connect it
to other monitors, but then you have to make your own cable.
> 3) Where can I find detailed programming info for the GFX9000?
You can get it with GFX9000, when you buy it. I don't know if there is any
information on the internet.
> 4) Do you know how fast this board is? I mean, how many frames per second
> can I get if I do an entire page copy in P1 or P2 mode (only the name
> table, not the pattern table).
I can't say this, but atleast I have heard, that copy operations are about
23 * faster than in V9938 (MSX2)
> 5) Can I switch from a GFX mode to a normal MSX screen by software?
Well, you have external monitor connector in GFX9000, so if you have
two monitors, then you can use them even at the same time.
,_____.
_=_=_=_=!_MSX_!=_=_=_=_=_=_=_=_,
! A1ST ~--- - I ( o o o o o o )i
/--------------------------------`,
/ .::::::::::::::::::::::;::; ::::.,
/ :::.:.:.:::____________:::::!. -=- `,
~======================================
NYYRIKKI : [EMAIL PROTECTED]
****
MSX Mailinglist. To unsubscribe, send an email to [EMAIL PROTECTED] and put
in the body (not subject) "unsubscribe msx [EMAIL PROTECTED]" (without the
quotes :-) Problems? contact [EMAIL PROTECTED] (www.stack.nl/~wiebe/mailinglist/)
****
