> I have a doubt though:
> Now I have two partitions:
> -A: FAT-12 partition
> -B: FAT-16 partition
> and of course C: which refers to the floppy disk drive.
> Why when I type 'D:' and then 'dir' an "Insert disk" message appears?
> Isn�t floppy disk drive C:? Then, why D: also refers to floppy disk drive?
If you try this without harddisk and you have only one diskdrive, the same
happens, but then with drive A and B of course. Try DIR B: or something if
you have only your floppydrive connected and not your harddisk.
It is very normal. Otherwise you could not copy to another disk with only
one diskdrive.
Best regards,
Manuel
---------------
Pre-PS: After 29/9/2000, I cannot use this address anymore. Therefore,
from 25/9/2000, please send all mail to [EMAIL PROTECTED], my always-
valid address. I can also read that mail from here in Japan. Thank you.
PS: MSX 4 EVER! (Questions? See: http://www.faq.msxnet.org/ )
PPS: Visit my home page at http://bilderbeek.cjb.net/
****
Problems? contact [EMAIL PROTECTED] See also http://www.faq.msxnet.org/
****
