OS: Fedora Core 1, Reader: SCM SCR331-DI
I have pcsc-lite-1.2.0 installed. testpcsc works.
ifdtest (from ifd-test-1.0) works. I don't have the /etc/readers.conf file
What is the version of the CCID driver? Use the last version. And the file is 'reader.conf' and not 'readers.conf'
However, when I try to get the JCOP plug-in to activate, I get in the JCOP Licensing Wizard alert the following error:
No card was detected in primary smart card reader! Reason: 0
Perhaps the problem is because my system thinks it sees two readers, when only one is plugged in?!
It see 2 readers because your system see the "Generic Reader" (see the trace below) declares in the file 'readers.conf'.
When I run ifdtest, I get
Reader 01: Generic Reader 0 0 Reader 02: SCR 331-DI 0 0 Enter the desired reader number :
Thus there are 2 readers for your system.
Find the file 'reader.conf' and comment all the entry with '#' and it will works when you restart pcscd.
I type in "2", and test A works
When I run test-ifd-0.1.4/testifddriver, I get a core dump if I execute
./testifddriver
Yes there are problem with this program I must improve it but I am too busy.
However, if I type
./testifddriver -n1
or
./testifddriver -n2
the tests complete without a sigfault. I get "Card protocol mismatch" but it says: PC/SC Lite Driver Tests Completed Successfully !
This is an other problem I will correct.
Do I need a reader.conf for the USB reader?
No
Regards, -- Damien Sauveron ----------------------------- LaBRI, Universit� Bordeaux 1 351, cours de la Lib�ration 33405 Talence cedex France Phone: On demand Fax: +33 5 40 00 66 69 -----------------------------
_______________________________________________ Muscle mailing list [EMAIL PROTECTED] http://lists.drizzle.com/mailman/listinfo/muscle
