Dear all,
The command of Card Power On and Card Reset is commands that deal with the card instead of the reader since it retrieve the ATR from the smart card. Right? I'm using a smart card of T=1 Protocol and when i sent this command, the response i receive will be in T1 Block since the card is using T=1 Protocol. So, it my data field of my response, i will have NAD, PCB, LEN byte of the T1 Block then follow by the ATR. Is that right?
Thanks for helping.
Regards,
Jackie Wong
How low will we go? Check out Yahoo! Messengers low PC-to-Phone call rates.
_______________________________________________ Muscle mailing list [email protected] http://lists.drizzle.com/mailman/listinfo/muscle
