There is a wiki at http://wiki.teuwen.org/TexasInstrumentsSmartCardController
Though I can't seem to get to it right now.. hmmm
~jacob
Quoting Ben <[EMAIL PROTECTED]>:
>
> Is there a driver around to support the Texas Instruments "PCI
GemCore
> based SmartCard Reader"? This is on an HP Compaq NC6400 notebook.
>
> 02:06.4 Communication controller: Texas Instruments Unknown device 803d
> Subsystem: Hewlett-Packard Company Unknown device 30ad
> Control: I/O- Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop-
> ParErr- Stepping- SERR- FastB2B-
> Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium
> >TAbort- <TAbort- <MAbort- >SERR- <PERR-
> Interrupt: pin A routed to IRQ 11
> Region 0: Memory at f4203000 (32-bit, non-prefetchable)
[size=4K]
> Region 1: Memory at f4204000 (32-bit, non-prefetchable)
[size=4K]
> Capabilities: [44] Power Management version 2
> Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA
> PME(D0+,D1+,D2+,D3hot+,D3cold-)
> Status: D0 PME-Enable- DSel=0 DScale=0 PME-
>
> Any help/support would be much appreciated.
>
> Ben
>
> _______________________________________________
> Muscle mailing list
> [email protected]
> http://lists.drizzle.com/mailman/listinfo/muscle
>
----------------------------------------------------------------
This message was sent using IMP, the Internet Messaging Program.
_______________________________________________ Muscle mailing list [email protected] http://lists.drizzle.com/mailman/listinfo/muscle
