Hello everyone, For a research project, I need a PCKS#11 capable smartcard and after stumbling over the musclecard project decided on JCOP31/36k cards from NXP (according to my information, those should support GP2.1.1, but I am open to corrections) to install the MuscleApplet on.
Sadly though, this is were I am still stuck. The JCOP Tools as available on a included CD crash somewhere in the constructor com.ibm.jc.terminal.NativeJCTerminal as soon as I try to connect to the card in the reader (Gemplus Twin via USB btw), and take Eclipse with them. Trying my luck under Linux, using GPShell, I managed to authenticate only in OP2.0.1 mode, not in GP2.1.1 mode (mutual authentication fails). Even if properly authenticated in OP2.0.1 mode though, a try at installing the HelloWorld Applet on the card with "install -f HelloWorld.cap" (and varying additional parameters) simply results in install_for_load() returns 0x80206A88 (6A88: Referenced data not found.) If anyone managed to install an applet on an JCOP31 using GPShell, or has a clue as to what I'm doing wrong here, a quick hint therefore would be greatly appreciated :) I know this is probably not the 100% correct location to ask for help with that kind of problem (as it is not yet Muscle specific), but I had the impression that a load of people read this list who might have already solved these starting problems and therefore hope you will forgive that slightly out of topic call for help. Kind regards and thanks for your time, Gina Häußge -- Dipl.-Inform. Gina Häußge RBG, FB20, TU Darmstadt Tel: +49 (0)6151 16 6655 Hochschulstr. 10 Fax: +49 (0)6151 16 4701 64289 Darmstadt S2|02 B120 _______________________________________________ Muscle mailing list [email protected] http://lists.drizzle.com/mailman/listinfo/muscle
