Can you give the output of gscanbus and 6200ch? Every DCT-6200 device I have seen thus far has been node 2.
jim DavidB <[EMAIL PROTECTED]> wrote [02.02.05]: > Jim, > > First off, Great Work! > > I am trying to get the firewire working and have not had any success. Here > is what I have done to this point: > > 1) Downloaded libraw1394 version 1.1.0 source, compiled and installed. > 2) Pulled down the trunk source for libiec61883 revision 49, compiled and > installed. > 3) Re-compiled 6200ch to use new libraw1394 and tested. (I have been using > this to change channels for a few months) > 4) Pulled down current CVS as of 11:00am today. Compiled, installed, and ran > setup. > 5) Configured a new Capture Card and selected port 0, node 1 (used gscanbus > and 6200ch -v to get values) > > When I manually schedule a program for a local channel I get the following > in the log file: > > 2005-02-02 14:04:36.657 FireWire: Initializing Port: 0, Node: 1, Speed: > 100Mbps > libiec61883 warning: Overlayed connection on channel 0. > You may need to manually set the channel on the receiving node. > 2005-02-02 14:04:36.661 FireWire: Created Channel: 0, Bandwidth Allocation: > 0 > 2005-02-02 14:04:36.661 FireWire: Changing Speed 200Mbps -> 100Mbps > 2005-02-02 14:04:51.656 Firewire: No Input in 15 seconds [P:0 N:1] (select) > > Is there anything that I can use to determine if everything is configured > correctly? > > As a note: I am doing all this work through an ssh session so I can only > test by scheduling a recording through mythweb. > > Any help would be appreciated. Thanks, > > David > > > _______________________________________________ > mythtv-dev mailing list > [email protected] > http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-dev
_______________________________________________ mythtv-dev mailing list [email protected] http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-dev
