On Wednesday 09 March 2005 22:39, Jarod Wilson wrote: > On Saturday 19 February 2005 07:33, thor wrote: > > Probably for Taylor: > > > > Snippet of console output from setup program scanning for channels (in a > > part of the channels where there is some actual QAM): [...] > > The dtv_multiplex table gets populated, but after the scan there are > > simply no channels listed. As I mentioned on IRC, I have a standalone > > samsung HDTV box, so I know that QAM is working on the cable. > > > > You probably need more output than that, but it's not immediately > > obvious to me what I need to do to SIPARSER() and SISCAN() defines in the > > .h's to make them produce more output. > > I'm in exactly the same boat. When I use azap w/the QAM256 channels.conf, > it shows locks on all the channels I'd expect to see locks on (and then > some) [...] > Is this possibly one of the issues some of the > recently-sent-to-the-dev-list DVB scanwizard clean-up patches should > address? Back to it, will probably give a few of 'em a shot this weekend if > nobody knows. :-)
Just started looking at the dvb mailing list. Too many lists, not enough time... A few others are running into the same thing. Even w/azap locking on, folks can't get data off cable, so it looks to me like a dvb driver issue. What driver versions are folks that have working cable HD w/their Air2PC running? I'm currently running a build from 2/28 cvs (w/Myth built against the same headers). About to cvs up again though... -- Jarod Wilson [EMAIL PROTECTED]
pgp4U1swzRaeK.pgp
Description: PGP signature
_______________________________________________ mythtv-dev mailing list [email protected] http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-dev
