Mark Spieth wrote:
#316: "Adjust Audio Sync" doesn't show current/last value
------------------------------+-------------------------------------------
--
Reporter: [EMAIL PROTECTED] | Owner: ijr
Type: defect | Status: new
Priority: minor | Milestone:
Component: mythtv | Version:
Severity: low | Cc: |
------------------------------+-------------------------------------------
--
Repeated use of the Adjust Audio Sync menu does not show the current
value
before adjusting.
Watch a program, adjust audio sync to some value, wait for OSD timeout.
Adjust audio sync again and it will be at zero (it should have displayed
the current/last value). Pressing "0" will reset to true zero and shows
the correction value.
yes I know :) didnt think it was that important as it makes things more
complex esp if you pressed 1 to resync a wildly out alignment.
Ill look into it. maybe even itegrate with isaacs changes to sync.
mark
------------------------------------------------------------------------
_______________________________________________
mythtv-dev mailing list
[email protected]
http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-dev
Thank you for the prompt reply. I wouldn't say it's important to fix,
but I do use it often to correct for some A/V delay somewhere in my
setup. It's a minor issue to remember that the slider is relative
instead of absolute.
But while we're on the topic, I'd actually be interested in some method
of "fixing" the value to a specific card or source (my DVB card doesn't
need the correction, but my analog satellite receiver does on the PVR
250 card).
# Endaf
_______________________________________________
mythtv-dev mailing list
[email protected]
http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-dev
