Steve Adeff <[EMAIL PROTECTED]> wrote [01.11.06]: > > the problem is that you can't control how the dct62xx comes up, some will > allow for broadcast connection, some will only work with p2p. I have it > setup as a firewire capture card, Cable Box Model DCT-6200, Connection Type > Point to Point, Port 0, Node 2. > > I can't enable bcast(it never =1), here's my plugreport:
I would suggest trying the following. Set the connection type to be broadcast in mythtv. Then reboot both your box and dct-6200 to make sure the firewire stuff is all clean. Dont issue do any plugctl commands when its back up. run 'test-mpeg2 -r 2 > test.ts' over and over until you get output. once you get output stop test-mpeg2 then attempt to watch livetv in myth. If livetv works you should be all set. If not, you will need to repeat the test-mpeg2 process until it does. It will usually take me a few (less then 10) tries to get it in a working state. This process should only be required if you reboot your box or dct-6200. basicly a cut/paste from 'Debugging Unreliable DCT-6200 Recording' thread on the -dev list from a few months back. jim _______________________________________________ mythtv-dev mailing list [email protected] http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-dev
