1) If I run that command after depmod -a and before modprobe ivtv, I am able to see the output clearly on the TV, with the exception of a light blue vertical line on the right side of the screen. dnr_mode, dnr_temporal, and dnr_spatial are all set at 0. How do I permanently enable that ivtvctl setting mentioned below?
2) As a separate issue, I can't get the hauppague grey remote for the PVR-350 model 990 to work. lircd is up and running, I copied the appropriate config file as per Jarrod's guide, but when I run /usr/bin/irw and press on the buttons nothing comes up on the screen. Yes, there are batteries in the remote :) Thanks in advance. Steve On Tue, 30 Nov 2004 12:04:54 +0100, Juan C. Gallardo <[EMAIL PROTECTED]> wrote: > I had the same problem, and it was because my card is a new model and > there has been some changes. > Try this to see if it works to you. > > #ivtvctl -j reg=0x6c,val=0x9a -d /dev/video0 > > then load the ivtv-fb module and try again. > If this works then it means that your pvr is model 993 or 991 (I am not > sure). > > Juan > > > > sdk wrote: > > >Flollowing Jarrod's Guide for FC2, am able to play output through the > >VGA , but when sending to the TV out of the PVR350 I get a green > >screen. I can barely see the TV signal behind the green screen. I had > >no problems when testing the test image for tv out using > >/sbin/modprobe saa7127 test_image=1 > > > >Help would be much appreciated. I couldnt find anything that fit this > >description on the archives or the TVout wiki . > > > >Thanks, > >Steve > > > > > >------------------------------------------------------------------------ > > > >_______________________________________________ > >mythtv-users mailing list > >[EMAIL PROTECTED] > >http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users > > > > > >
_______________________________________________ mythtv-users mailing list [EMAIL PROTECTED] http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
