I think this would be better suited for ivtv users list but you're all very good at this and may know if my kernel needs to be patched and if my 350 Card loaded Corectly.
ivtv: ==================== START INIT IVTV ==================== ivtv: version 0.2.0 (rc3b) loading ivtv: Linux version: 2.6.8-24.10-default 586 REGPARM gcc-3.3 ivtv: In case of problems please include the debug info ivtv: between the START INIT IVTV and END INIT IVTV lines when ivtv: mailing the ivtv-devel mailinglist. ivtv: Autodetected WinTV PVR 350 card ivtv: Found an iTVC15 based chip ACPI: PCI interrupt 0000:00:09.0[A] -> GSI 10 (level, low) -> IRQ 10 ivtv: VIA PCI device: 0x3205 vendor: 0x1106 i2c-algo-bit.o: (0) scl=1, sda=1 i2c-algo-bit.o: (1) scl=1, sda=0 i2c-algo-bit.o: (2) scl=1, sda=1 i2c-algo-bit.o: (3) scl=0, sda=1 i2c-algo-bit.o: (4) scl=1, sda=1 i2c-algo-bit.o: ivtv i2c driver #0 passed test. ivtv: i2c attach [client=unset,ok] evdev_connect: evdev dde13240 handle dde1325c name event3 ir-kbd-i2c: i2c IR (Hauppauge) detected at i2c-0/0-0018/ir0 [ivtv i2c driver #0] tveeprom: Hauppauge: model = 48132, rev = K268, serial# = 2867327 tveeprom: tuner = LG TAPE H001F MK3 (idx = 68, type = 47) tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000) tveeprom: audio_processor = MSP3440 (type = 11) ivtv: i2c attach [client=tveeprom[2],ok] tuner: chip found at addr 0xc2 i2c-bus ivtv i2c driver #0 ivtv: i2c attach [client=(tuner unset),ok] saa7115: starting probe for adapter ivtv i2c driver #0 (0x10005) saa7115: detecting saa7115 client on address 0x42 saa7115: writing init values ivtv: i2c attach [client=saa7115[2],ok] saa7115: status: (1E) 0x48, (1F) 0xe0 saa7127: Selecting NTSC video Standard saa7127: Selecting S-Video+Composite saa7127: Turn WSS off saa7127: Widescreen Mode 4:3 Full Format saa7127: Selecting Normal Encoder Input saa7127: Enable Video Output ivtv: i2c attach [client=saa7127[2],ok] msp34xx: ivtv version msp34xx: init: chip=MSP3448W-A2, has NICAM support, simple (D) mode, simpler (G) no-thread mode msp34xx: $Id$ compiled on: Nov 2 2005 11:38:58 ivtv: i2c attach [client=MSP3448W-A2,ok] ivtv: Tuner Type 47, Tuner formats 0x00001000, Radio: yes, Model 0x00ad2598, Revision 0x00000001 ivtv: NTSC tuner detected ivtv: Radio detected ivtv: Encoder revision: 0x02040024 ivtv: Encoder Firmware is buggy, use version 0x02040011 ivtv: Decoder revision: 0x02020023 ivtv: Configuring WinTV PVR 350 card with 9 streams ivtv: Create DMA stream 0 using 256 16384 byte buffers 4194304 kbytes total ivtv: Registered v4l2 device, streamtype 0 minor 0 ivtv: Create DMA stream 1 ivtv: Registered v4l2 device, streamtype 1 minor 32 ivtv: Create stream 2 using 40 52224 byte buffers 2097152 kbytes total ivtv: Registered v4l2 device, streamtype 2 minor 224 ivtv: Create DMA stream 3 using 455 4608 byte buffers 2097152 kbytes total ivtv: Registered v4l2 device, streamtype 3 minor 24 ivtv: Create stream 4 ivtv: Registered v4l2 device, streamtype 4 minor 64 ivtv: Create DMA stream 5 using 16 65536 byte buffers 1048576 kbytes total ivtv: Registered v4l2 device, streamtype 5 minor 16 ivtv: Create stream 6 using 1024 2048 byte buffers 262144 kbytes total ivtv: Registered v4l2 device, streamtype 6 minor 228 ivtv: Create stream 7 ivtv: Registered v4l2 device, streamtype 7 minor 232 ivtv: Create DMA stream 8 ivtv: Registered v4l2 device, streamtype 8 minor 48 ivtv: Setting Tuner 47 tuner: type set to 47 (LG NTSC (TAPE series)) by ivtv i2c driver #0 ivtv: Setting audio matrix to input 3, output 1 ivtv: Switching standard to NTSC. ivtv: ivtv_enc_thread: pid = 13826, itv = 0xdf4398a0 ivtv: ivtv_dec_thread: pid = 13827, itv = 0xdf4398a0 saa7115: decoder set norm NTSC saa7115: set audio: 0x01 saa7127: Setting Encoder Video Standard saa7127: Set NTSC Video Mode saa7127: Selecting NTSC video Standard ivtv: Initialized WinTV PVR 350, card #0 ivtv: ==================== END INIT IVTV ====================
_______________________________________________ mythtv-users mailing list [email protected] http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
