But, most likely your problem is your config file or your possitioning of the device in respect to your box. Do you have the device extremely close to the IR receiver of your cable box? (See picture on www.irblaster.info )
The only way for you to record a config is to build or buy an ir receiver that works with lirc. You shouldn't have to do this though because you are not the only person on this list and the lirc list using an SA3200.
STEPHEN WANAMAKER wrote:
As recommended, I tried executing the channel change script while holding the other end of the IR blaster to a camera to ensure that the blaster was attempting to flash the signals. This was sucessful and I was able to see it attempt to flash the signals. So at this point I am assuming that the lirc setup is 100% working, and I am just missing the correct lirc.conf for my settop box. Would you say that is accurate? If no config exists for the SA 3200, is there no way to generate one?
_______________________________________________ mythtv-users mailing list [email protected] http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
